ET CPU-controlled Auto Booster Silent Pump(No Rust)

Built-in microchip control. Automatic power off when no water is detected within 60 seconds, to avoid the motor being burn up.
For 60Hz countries, We use dual-voltage 110/220V design, you can adjust the required voltage inside control box.
Low operation noise. The supply of water pressure is stable, and the water pressure will not change suddenly when taking a hot bath. The water temperature will not suddenly become cold or hot.
All-in-one design, compact size saves installation space.
The pump casing structure is made of reinforced plastic steel, and the wetted parts are not rust or create rust water. The motor shaft also will not get stuck easily due to leave unused for a long time.
Built-in thermal switch, mainly to avoid frequent ON/OFF or nonstop running which lead to outlet pipeline to burst out by water overheating.
If the pump is installed outdoors, it is recommended to install a protective cover on the ET pump. It can protect the pump and electronic components from heavy rain, wind and direct sunburn, to extend product life.

Production & Assembly Line of ET pump in EVERGUSH Headquarters,Kaohsiung Taiwan. All ET pumps are 100% strictly inspected and tested.

Auto boost water pressure to the house, apartment, villa,school, restaurant, school, beauty shop,...etc.
Auto boost water pressure to garden sprinkler, heater,toilet, washing machine, sanitary equipment,...etc.

Installed on the top floor of the building indoors, it automatically pressurizes water downwards.

Automatically pressurizes water downwards to supply users on high floors of the building

Installed on the top floor of the building indoors, it pressurizes water downwards to supply users on high floors.

Installed on the top floor of the building outdoors(Add individual awnings), it pressurizes water downwards to supply users on high floors.

Installed on the top floor of the building outdoors, it pressurizes water downwards to supply users on high floors.

Ambient Temp.: Max.40℃
Liquid Temp.: 0~40℃.
Relative humidity: Max.85%(RH).
Working pressure: Max. 5 bar.
Before starting the pump, make sure that the inlet water pressure cannot be greater than pre-set activation pressure from the factory.
Applicable liquids: drinking water or other liquids that are not corrosive and have characteristics close to clean water.
Not suitable for pumping groundwater or hot water which is over 40℃.

Output: 1/4HP(180W);1/2HP(380W);1HP(750W)
Motor Protection: IP54
Motor Insulation: E class.
Enclosed Fan-cooled 2P Induction Motor.Built-in Motor Overload Protector.
Voltage: Single phase110/220V(Dual-voltage)*60Hz ; 220~240V*50Hz(Customized)
Inlet/Outlet: 3/4” or 1”
Pre-set Activation Pressure: ET200:1.2 bar, ET400: 1.6 bar, ET800: 2.0 bar
Standard Performance for 60Hz Model: ET200:15M*30LPM ; ET400: 20M*30LPM ; ET800: 25M*40LPM
Standard Performance for 50Hz Model: ET200:15M*36LPM ; ET400: 20M*40LPM ; ET800: 25M*45LPM